Oil change – Honda Civic

Over the next steps you will learn how to change the oil in a Honda Civic 8th generation. Just follow these instructions.

Instructions:
1. Start the engine for several minutes before starting the exchange.
2. Put the car on jack for access under it. Oil filter cap is colored blue and red leak.
3. Open hood and remove the engine cover, where they put the oil. This way the oil will drain faster.
4. Under the car, remove the lid and put the oil leak tray and positioned exactly in the right hole.
5. After leaking the oil, remove the filter with a key. The oil filter will leak so be careful.
6. Fitted new filter. Put a little oil on the tray liner. Strange filter by hand.
7. Remove the old aluminum seal on the cover for leakage and replaces it. Put the cover. On it you can collect the key for the sealing gasket to deform.
8. Now put the oil. Use a funnel and put about 3.5-4 liters of oil.
9. Start the engine a bit and check the oil level using the rod.
10. To reset the oil life on board computer, click the button SEL / oil reset until menu appears. Hold 10 seconds until the button icon flashes. May you still pressed 5 seconds until it resets.
Warning:
• Change oil your own risk. If you are not sure what you go to a car service.

How do you charge the battery with another car ?

It’s easy to do one oil change to engine. Thus you can save a significant amount of money. Just follow these instructions.

Instructions
1. Park the car with the battery loaded closer to the other vehicle. Should be sufficiently close to the wires to reach from one battery to another.
2. Raise the hood of every car and put your gloves and goggles.
3. Connect the terminals so that they will be identical polarities (positive to positive and negative to negative). Positive terminal is red and negative terminal is black.
4. Now connect the other end of the wire and the other battery. It is better to connect the negative terminal first and then the positive terminal.
5. Make sure the wires do not sit on the engine cooling fan. Start the car engine with charged battery and let it start a few minutes. Now you can start the car with Battery.

6. Once you start the car with the Battery you can disconnect the wires.

Attention!

• During the process it is possible that sparks will jump, so be sure there are no flammable liquids nearby.

Watch tweets on: